Template:Short description Template:Infobox Unit The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada.<ref>Board foot</ref> It equals the volume of a board that is Template:Convert in length, one foot in width, and Template:Convert in thickness, or exactly Template:Val liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT, or BF. A thousand board feet can be abbreviated as MFBM, MBFT, or MBF. Similarly, a million board feet can be abbreviated as MMFBM, MMBFT, or MMBF.
Until the 1970s, in Australia and New Zealand, the terms super foot and superficial foot were used with the same meaning.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref><ref>{{#invoke:citation/CS1|citation |CitationClass=web }} Template:Webarchive</ref><ref>{{#invoke:citation/CS1|citation |CitationClass=web }} Template:Webarchive</ref>
DescriptionEdit
One board foot equals:
- 1 ft × 1 ft × 1 in
- 12 in × 12 in × 1 in
- 12 ft × 1 in × 1 in
- 144 cu in
- Template:Frac cu ft
- ≈ Template:Convert
- ≈ Template:Convert
- ≈ Template:Convert or steres
- Template:Frac Petrograd Standard of board
UsageEdit
The board foot is used to measure both rough (unprocessed) lumber and planed (surfaced) lumber. Rough lumber is measured before drying and planing, using its full sawn dimensions. Planed lumber, such as standard softwood "two by four" boards sold at retail, is measured using nominal dimensions—typically Template:Convert—even though the actual size is only about Template:Convert after processing. Despite the reduction in size due to drying and planing, nominal dimensions are still used when calculating board feet for surfaced softwood lumber. This convention simplifies pricing and standardization but may result in board footage values that do not reflect the true volume of wood in the final product. Essentially, the nominal dimensions assume a larger volume than the actual board contains, which is especially relevant when estimating material needs or costs. <ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> For planed lumber, board footage is calculated using the nominal width and thickness, and the actual length of the board. This reflects the lumber’s original rough size before drying and surfacing. For rough lumber, board footage is calculated using the actual width, thickness, and length of the board.
See dimensional lumber for a full explanation of nominal versus actual dimensions. Briefly, for softwoods:
- Subtract Template:Convert from nominal sizes under 2 inches,
- Subtract Template:Convert from nominal sizes between 2 and 8 inches,
- Subtract Template:Convert for nominal sizes over 8 inches.<ref>{{#invoke:citation/CS1|citation
|CitationClass=web }}</ref>
The system is less complex for hardwoods, because actual board measurements are used.
See alsoEdit
- Lumber#Dimensional lumber
- Metrication in Canada
- Cord (unit)
- Cubic ton
- Forest product
- Hoppus foot
- Imperial units
- List of unusual units of measurement
- Measurement Canada
- Standard (timber unit)
- Stere
- United States customary units
- Units of measurement
- Weights and Measures Act (Canada)
ReferencesEdit
External linksEdit
Template:Systems of measurement Template:United States Customary Units