Editing Shadow volume (section)

== Construction ==

In order to construct a shadow volume, project a ray from the light source through each vertex in the shadow casting object to some point (generally at infinity). These projections will together form a volume; any point inside that volume is in shadow, everything outside is lit by the light.

For a polygonal model, the volume is usually formed by classifying each face in the model as either facing toward the light source or facing away from the light source. The set of all edges that connect a toward-face to an away-face form the ''silhouette'' with respect to the light source. The edges forming the silhouette are extruded away from the light to construct the faces of the shadow volume. This volume must extend over the range of the entire visible scene; often the dimensions of the shadow volume are extended to infinity to accomplish this (see ''[[Shadow volume#Optimization|optimization]]'' below.) To form a closed volume, the front and back end of this extrusion must be covered. These coverings are called "caps". Depending on the method used for the shadow volume, the front end may be covered by the object itself, and the rear end may sometimes be omitted (see ''[[Shadow volume#Depth pass|depth pass]]'' below).

There is also a problem with the shadow where the faces along the silhouette edge are relatively shallow. In this case, the shadow an object casts on itself will be sharp, revealing its polygonal facets, whereas the usual lighting model will have a gradual change in the lighting along the facet. This leaves a rough shadow artifact near the silhouette edge which is difficult to correct. Increasing the polygonal density will minimize the problem, but not eliminate it. If the front of the shadow volume is capped, the entire shadow volume may be offset slightly away from the light to remove any shadow self-intersections within the offset distance of the silhouette edge (this solution is more commonly used in [[shadow mapping]]).

The basic steps for forming a shadow volume are:

# Find all [[silhouette edge]]s (edges which separate front-facing faces from back-facing faces)
# Extend all silhouette edges in the direction away from the light-source
# Add a ''front-cap'' and/or ''back-cap'' to each surface to form a closed volume (may not be necessary, depending on the implementation used)

[[File:Shadow volume illustration.png|centre|thumb|500px|Illustration of shadow volumes. The image above at left shows a scene shadowed using shadow volumes. At right, the shadow volumes are shown in wireframe. Note how the shadows form a large conical area pointing away from the light source (the bright white point).]]