Editing Sheepshank (section)

== Construction methods ==
A sheepshank knot may be constructed as follows: ...
* Pull a section of rope back and lay it alongside the rope, so that the rope forms a Z approximately 20&nbsp;cm long.
* Flatten the Z so that there are 3 sections of rope lying alongside each other, with two U-bends where the rope reverses direction.
* At each U-bend, grasp the U-bend in one hand, thus holding two of the rope sections. With the other hand form a small loop in the remaining section and draw it over the U-bend so that the loop forms a half hitch and stays there if the free end of the rope is pulled taut.
:: Many people draw the small loop over facing the wrong way at least half of the time.  Instead, make with the U a half-hitch around the other part, by tucking through, then pull the U straight.
* Repeat at the other U-bend.

An alternative method for quickly constructing a sheepshank is as follows:

* Create a simple loop in the rope, so that the (left) leading end is on top of the (right) trailing end of the loop.
* Repeat this process further down the rope to create 3 total loops that overlap slightly (similar to a [[venn diagram]] with three circles).
* Reach through the outer two loops and grab either side of the middle loop and pull outward while also keeping the rest of the rope slightly taut.
* Once the middle loop is pulled through the outer loops, pull on the free ends of the rope to secure.

The result is a flattened loop which is held at each end by a [[half hitch]]. If the sides of the flattened loop are pulled away from each other, the flattened loop ends pull out of the half hitches and the knot falls apart, but if the free ends
are pulled taut then the knot remains secure.