Editing Vehicle bus (section)

== Background ==
The main driving forces for the development of vehicle network technology have been the advances made in the [[electronics industry]] in general and government regulations imposed, especially in the United States, in order to make the automobiles environmentally friendly.

With stringent [[emission standard]]s for automobiles, it became impossible to attain the required degree of control without the help of on-board computing devices.  On-board electronic devices have also contributed substantially to vehicle performance, occupant comfort, ease of manufacture and cost effectiveness.

At one time, a [[car radio]] was likely the only electronic device in an automobile, but now almost every component of the vehicle has some electronic feature.  Typical electronic modules on today's vehicles include the [[Engine Control Unit]] (ECU), the [[Transmission Control Unit]] (TCU), the [[Anti-lock Braking System]] (ABS) and [[body control module]]s (BCM).

An electronic control module typically gets its input from sensors (speed, temperature, pressure, etc.) that it uses in its computation. Various [[actuators]] are used to enforce the actions determined by the module (turn the cooling fan on, change gear, etc.). The modules need to exchange data among themselves during the normal operation of the vehicle. For example, the engine needs to tell the transmission what the engine speed is, and the transmission needs to tell other modules when a gear shift occurs. This need to exchange data quickly and reliably led to the development of the vehicle network, as the medium of data exchange.

The automotive industry quickly realized the complexity of wiring each module to every other module. Such a wiring design would not only be complex, it would have to be altered depending on which modules were included in the specific vehicle. For example, a car without the anti-lock brake module would have to be wired differently than one that included anti-lock brakes.

The industry's answer to this problem was to create a central network in the vehicle. Modules could be 'plugged' into the network and would be able to communicate with any other module that was installed on the network. This design was easier to manufacture, easier to maintain and provided the flexibility to add and remove options without affecting the entire vehicle's wiring architecture. Each module, a node on the vehicle network, controls specific components related to its function and communicates with the other modules as necessary, using a standard [[Communications protocol|protocol]], over the vehicle network.

Networks were not new, but their application to the vehicle was. The networks for the vehicles called for:
*Low cost
*Immunity from external noise
*Ability to operate in harsh environments
*Overall robustness and reliability

Although the vehicle network made modest demands on data [[throughput]], the demand for more on-board computing is continuing to drive changes to these networks to provide higher-speed communication between modules.  The control area network include the receiver and transmitter for the host to controller transmission and interlinking between the computers