Editing Ski boot (section)

==Snowboarding==
[[File:Snowboard-Negative0-18-16A(1).jpg|thumb|left|Typical [[snowboarding|snowboard]] gear consists of an L-shaped plastic frame for the bindings, and semi-stiff boots on the feet. Ratcheting buckles hold the boots in the frame. These are generally far more comfortable than typical alpine boots.]]
Downhill techniques, alpine, telemark and snowboarding, all perform turns by rotating the ski or board onto its edge. Once on edge, the curved pattern cut into the side (the "sidecut") causes the ski or board to bend into a curve. As they move forward over the snow, this curved shape causes them to turn.

[[Snowboard]] boots and bindings are normally far simpler than their downhill counterparts, rarely including release systems for instance, and need to provide mechanical support only in the fore and aft directions. These typically consist of an external frame, generally L-shaped, which the snowboarder steps into and then fastens down using straps over the boot. The boot itself is not as responsible for transmitting forces, and can be much softer than a typical downhill boot. When the sport was first introduced, normal winter boots were used, but today it is much more common to use semi-stiff snowboarding boots. Some specialty disciplines use harder boots with step-in bindings more similar to downhill systems, but these are not widely used outside these fields, even though some downhill sports teachers use these so they can switch between snowboarding or skiing classes without having to change boots.