Editing Engineering drawing (section)

=== Showing dimensions ===
The required sizes of features are conveyed through use of ''dimensions.'' Distances may be indicated with either of two standardized forms of dimension: linear and ordinate.
* With ''linear'' dimensions, two parallel lines, called "extension lines," spaced at the distance between two features, are shown at each of the features. A line perpendicular to the extension lines, called a "dimension line," with arrows at its endpoints, is shown between, and terminating at, the extension lines. The distance is indicated numerically at the midpoint of the dimension line, either adjacent to it, or in a gap provided for it.
* With ''ordinate'' dimensions, one horizontal and one vertical extension line establish an origin for the entire view. The origin is identified with zeroes placed at the ends of these extension lines. Distances along the x- and y-axes to other features are specified using other extension lines, with the distances indicated numerically at their ends.
Sizes of circular features are indicated using either diametral or radial dimensions. Radial dimensions use an "R" followed by the value for the radius; Diametral dimensions use a circle with forward-leaning diagonal line through it, called the ''diameter symbol'', followed by the value for the diameter. A radially-aligned line with arrowhead pointing to the circular feature, called a ''leader'', is used in conjunction with both diametral and radial dimensions.
All types of dimensions are typically composed of two parts: the ''nominal'' value, which is the "ideal" size of the feature, and the ''tolerance'', which specifies the amount that the value may vary above and below the nominal.
* [[Geometric dimensioning and tolerancing]] is a method of specifying the functional geometry of an object.