Editing Image intensifier (section)

===MTF (modulation transfer function)===
The [[modulation transfer function]] of an image intensifier is a measure of the output amplitude of dark and light lines on the display for a given level of input from lines presented to the photocathode at different resolutions. It is usually given as a percentage at a given frequency (spacing) of light and dark lines. For example, if you look at white and black lines with a MTF of 99% @ 2 lp/mm then the output of the dark and light lines is going to be 99% as dark or light as looking at a black image or a white image. This value decreases for a given increase in resolution also. On the same tube if the MTF at 16 and 32 lp/mm was 50% and 3% then at 16 lp/mm the signal would be only half as bright/dark as the lines were for 2 lp/mm and at 32 lp/mm the image of the lines would be only three percent as bright/dark as the lines were at 2 lp/mm.

Additionally, since the limiting resolution is usually defined as the point at which the MTF is three percent or less, this would also be the maximum resolution of the tube. The MTF is affected by every part of an image intensifier tube's operation and on a complete system is also affected by the quality of the optics involved. Factors that affect the MTF include transition through any fiber plate or glass, at the screen and the photocathode and also through the tube and the microchannel plate itself. The higher the MTF at a given resolution, the better.