Editing Collet (section)

====ER collets====
[[File:ER Collet.jpg|thumb|upright|ER Collet ]]
The "ER" collet system, developed and patented by Swiss manufacturer Rego-Fix in 1972, and standardized as DIN 6499, is the most widely used tool clamping system in the world and today available from many producers worldwide.<ref>{{cite web |url=http://www.rego-fix.com/collets/ |title=REGO-FIX® ER Collets |access-date=2012-09-12 |url-status=dead |archive-url=https://web.archive.org/web/20120922032100/http://www.rego-fix.com/collets/ |archive-date=2012-09-22 }}</ref><ref>{{cite book|title=Machinery's Handbook 28th edition|date=2008|page=947}}</ref> The standard series are: ER-8, ER-11, ER-16, ER-20, ER-25, ER-32, ER-40, and ER-50. The "ER" name came from an existing "E" collet (which were a letter series of names) which Rego-Fix modified and appended "R" for "Rego-Fix". The series number is the opening diameter of the tapered receptacle, in millimetres. ER collets collapse  to hold parts up to 1&nbsp;mm smaller than the nominal collet internal size in most of the series (up to 2&nbsp;mm smaller in ER-50, and 0.5&nbsp;mm in smaller sizes) and are available in 1&nbsp;mm or 0.5&nbsp;mm steps.  Thus a given collet holds any diameter ranging from its nominal size to its 1-mm-smaller collapsed size, and a full set of ER collets in nominal 1&nbsp;mm steps fits any possible cylindrical diameter within the capacity of the series. With an ER fixture chuck, ER collets may also serve as workholding fixtures for small parts, in addition to their usual application as toolholders with spindle chucks.<ref>{{cite web |url=http://www.rego-fix.com/catalog/pdfs/14_Technical.pdf |title= |website=www.rego-fix.com |archive-url=https://web.archive.org/web/20141227213810/http://www.rego-fix.com/catalog/pdfs/14_Technical.pdf |archive-date=December 27, 2014}}</ref>  Although a metric standard, ER collets with internal inch sizes are widely available for convenient use of imperial sized tooling.  The spring geometry of the ER collet is well-suited only to cylindrical parts, and not typically applied to square or hexagonal forms like 5C collets.