Editing Combine harvester (section)

==Conventional combine==
{{Unreferenced section|date=April 2024}}
The cut crop is carried up the feeder throat (commonly called the "feederhouse"), by a ''chain and flight elevator'', then fed into the threshing mechanism of the combine, consisting of a rotating ''threshing drum'' (commonly called the "cylinder"), to which grooved steel bars (rasp bars) are bolted.  The rasp bars thresh or separate the grains and chaff from the straw through the action of the cylinder against the ''concave'', a shaped "half drum", also fitted with steel bars and a meshed grill, through which grain, chaff and smaller debris may fall, whereas the straw, being too long, is carried through onto the ''straw walkers''. This action is also allowed because grain is heavier than straw, which causes it to fall rather than "float" across from the cylinder/concave to the walkers. The drum speed is variably adjustable on most machines, whilst the distance between the drum and concave is finely adjustable fore, aft and together, to achieve optimum separation and output. Manually engaged ''disawning plates'' are usually fitted to the concave. These provide extra friction to remove the [[awn (botany)|awn]]s from [[barley]] crops. After the primary separation at the cylinder, the clean grain falls through the concave and to the shoe, which contains the chaffer and sieves. The shoe is common to both conventional combines and rotary combines.