Editing Pencil sharpener (section)

=== Prism sharpeners ===
{{original research|section|date=October 2024}}
[[File:KUM Sharpener.jpg|thumb|[[Magnesium alloy]] prism sharpener]]
So-called "prism" sharpeners, also called "manual" or "pocket" sharpeners in the United States, have no separate moving parts and are typically the smallest and cheapest commonly used pencil sharpener on the market. The simplest common variety is a small rectangular [[prism (geometry)|prism]] or block, only about 1 × 5/8 × 7/16&nbsp;inch (2.5 × 1.7 × 1.1&nbsp;cm) in size. The block-shaped sharpener consists of a combined point-shaping cone that is aligned to the cylindrical pencil alignment guide hole, into which the pencil is inserted. A sharp blade is mounted so that its sharp edge just enters the shaping cone [[tangent]]ially. The pencil is inserted into the sharpener and rotated while the sharpener is held motionless. The body of the sharpener is often contoured, ridged or grooved to make the small block easier to firmly grip, and is typically made of [[aluminum alloy]], [[magnesium alloy]] or hard [[plastic]].

[[File:Taille crayon mécanique-h.jpg|thumb|upright|An unusual hand-cranked prism sharpener, with a shavings cover]]
The blade inside the sharpener shaves the wood and graphite tip of the pencil, while the shavings emerge through a slot along the blade edge. It is important that the cylindrical alignment hole closely fits the diameter of the pencil, to keep the pencil from wobbling, which would cause stepped or lurching cut-depths and point breakage. Another important feature is a larger clearance hole at the end of the cone allowing sections of the pencil lead which break away to be removed with only minor inconvenience. Prism sharpeners can be bare or enclosed in a container to collect the shavings, while some enclosed sharpeners may be harder to clear in the event of a blockage.

A few prism sharpeners are hand-cranked, rotating the cutting blade instead of rotating the pencil. Moderate care is needed to not break the tip of the pencil being sharpened, requiring the pencil to be sharpened again. However, because pencils may have different standard diameters in different nations, imported sharpeners may have non-standard-sized alignment guide-holes, making sharpening attempts difficult. If the alignment hole is too small, the pencil cannot be inserted, while if it is too large, the tip of the pencil will repeatedly break off. Prism sharpeners may be right- or left-handed, requiring clockwise or counter-clockwise rotation of the pencil being sharpened.