Editing Dynamometer (section)

==Detailed dynamometer description==
[[Image:Dynamometer01CJC.svg|thumb|right|Electrical dynamometer setup showing engine, torque measurement arrangement and tachometer]]

A dynamometer consists of an absorption (or absorber/driver) unit, and usually includes a means for measuring torque and rotational speed. An absorption unit consists of some type of rotor in a housing. The rotor is coupled to the engine or other equipment under test and is free to rotate at whatever speed is required for the test. Some means is provided to develop a braking torque between the rotor and housing of the dynamometer. The means for developing torque can be frictional, hydraulic, electromagnetic, or otherwise, according to the type of absorption/driver unit.

One means for measuring torque is to mount the dynamometer housing so that it is free to turn except as restrained by a torque arm. The housing can be made free to rotate by using [[trunnion]]s connected to each end of the housing to support it in pedestal-mounted trunnion bearings. The torque arm is connected to the dyno housing and a [[weighing scale]] is positioned so that it measures the force exerted by the dyno housing in attempting to rotate. The torque is the force indicated by the scales multiplied by the length of the torque arm measured from the center of the dynamometer. A [[load cell]] [[transducer]] can be substituted for the scales in order to provide an [[Signal (electrical engineering)|electrical signal]] that is proportional to torque.

Another means to measure torque is to connect the engine to the dynamo through a [[torque sensor|torque sensing]] coupling or torque transducer. A torque transducer provides an electrical signal that is proportional to the torque.

With electrical absorption units, it is possible to determine torque by measuring the current drawn (or generated) by the absorber/driver. This is generally a less accurate method and not much practiced in modern times, but it may be adequate for some purposes.

When torque and speed signals are available, test data can be transmitted to a [[data acquisition]] system rather than being recorded manually. Speed and torque signals can also be recorded by a [[chart recorder]] or [[plotter]].