Editing Meiobenthos (section)

===Extraction methodologies===
There are a wide variety of methods for extracting meiofauna from the samples of their habitat depending upon whether live or fixed specimens are required.  For extracting live meiofauna, one has to contend with the large number of species that cling or attach themselves to the substrate when disturbed.  In order to get the meiofauna to release their grip, there are three methodologies available.

The first, and simplest, is [[osmotic shock]], which is achieved by submerging the sample in fresh water for a few seconds (this only works for marine samples). This will cause the organisms to release, after which they can be shaken free from the substrate and filtered out through a 45&nbsp;μm mesh and immediately returned to fresh filtered seawater.  Many organisms will come through this process unharmed as long as the osmotic shock does not last too long.

The second methodology is the use of an [[anaesthetic]]. The preferred [[Solution (chemistry)|chemical solution]] for meiobenthologists is [[Tonicity|isotonic]] [[magnesium chloride]] (7.5g&nbsp;MgCl<sub>2</sub>·6H<sub>2</sub>O per 100&nbsp;mL of distilled water). The sample is immersed in the isotonic solution and left for a period of 15&nbsp;min, after which the meiofauna are shaken free of the substrate and again filtered out through a 45&nbsp;μm mesh and immediately returned to fresh filtered seawater.

The third methodology is Uhlig's seawater ice technique.<ref>{{Cite journal |last1=Uhlig |first1=G. |last2=Thiel |first2=H. |last3=Gray |first3=J. S. |date=1973-05-01 |title=The quantitative separation of meiofauna |journal=Helgoländer wissenschaftliche Meeresuntersuchungen |language=en |volume=25 |issue=1 |pages=173–195 |doi=10.1007/BF01609968 |bibcode=1973HWM....25..173U |s2cid=46016793 |issn=1438-3888|doi-access=free }}</ref> This relies on the organisms moving ahead of a front of ice-cold seawater moving down through the sample, ultimately forcing them out of the sediment. It is most effective on samples from temperate and tropical regions.

For major studies where large numbers of samples are collected concurrently, samples are normally fixed using a 10% [[formalin]] solution, and the meiofauna are extracted at a later date. There are two main extraction methodologies. The first, [[decantation]], works best with coarse sediments. Samples are shaken in an excess of water, the sediment is briefly allowed to settle, and then the meiofauna are filtered off. The second methodology, the flotation technique, works best with finer sediments, where the mass of the sediment particles is close to that of the meiofauna. The best solution for this technique is the [[colloidal silica]] Ludox. The sample is stirred into the Ludox solution and left to settle for 40&nbsp;min, after which the meiofauna are filtered out. In fine sediments, extraction efficiency is improved with [[centrifugation]]. With both methodologies, repeated extractions should be made (at least three) with each sample to ensure that at least 95% of the meiofauna is extracted.