Editing HomePlug (section)

===HomePlug 1.0===
The first HomePlug specification, HomePlug 1.0, provides a peak PHY-rate of 14&nbsp;Mbit/s. It was first introduced in June, 2001 and has since been replaced by HomePlug AV. On May 28, 2008 [[Telecommunications Industry Association]] (TIA) incorporated HomePlug 1.0 powerline technology into the newly published TIA-1113 international standard. TIA-1113 defines modem operations on user-premises electrical wiring. The new standard is the world's first multi-megabit powerline communications standard approved by an American National Standards Institute (ANSI)-accredited organization.{{Citation needed|date=February 2012}}

The HomePlug 1.0 MAC Layer uses channel access based on Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) to transport data from 46 to 1500 bytes long from encapsulated IEEE 802.3 frames as MAC Service Data Units (MSDUs) (so doesn't support jumbo frames).{{citation needed|date=June 2024}}

HomePlug 1.0 Turbo adapters comply with the HomePlug 1.0 specification but employ a faster, proprietary mode that increases the peak PHY-rate to 85&nbsp;Mbit/s. HomePlug 1.0 Turbo modems were only available from Intellon Corporation.{{citation needed|date=June 2024}}