Editing Inline skates (section)

===Bearings===

Two bearings are used per wheel. The bearings slip into openings molded into each side of the wheel hub, and a flange molded into the wheel hub holds the bearings the correct distance apart. Additionally there is an axle spacer either machined into the axle or that slides over the axle (depending on the axle system used). Since the outer race of the bearing contacts the wheel spacer and the inner race of the bearing contacts the axle spacer, it is critical that the relationship between these two spacers is correct. If the wheel spacer is wider than the axle spacer the bearings will bind when the axle bolt (or bolts) are tightened.{{Citation needed|date=March 2015}}