Editing Bit error rate (section)

==={{anchor|QRSS}}Common types of BERT stress patterns===
*'''PRBS''' ([[pseudorandom binary sequence]]) – A pseudorandom binary sequencer of N Bits. These pattern sequences are used to measure [[jitter]] and eye mask of TX-Data in electrical and optical data links.
*'''QRSS''' (quasi random signal source) – A pseudorandom binary sequencer which generates every combination of a 20-bit word, repeats every 1,048,575 words, and suppresses consecutive zeros to no more than 14. It contains high-density sequences, low-density sequences, and sequences that change from low to high and vice versa. This pattern is also the standard pattern used to measure jitter.
*'''3 in 24''' – Pattern contains the longest string of consecutive zeros (15) with the lowest ones density (12.5%). This pattern simultaneously stresses minimum ones density and the maximum number of consecutive zeros.  The [[D4 framing standard|D4]] frame format of 3 in 24 may cause a D4 [[Remote alarm indication|yellow alarm]] for frame circuits depending on the alignment of one bits to a frame.
*'''1:7'''  – Also referred to as ''1 in 8''.  It has only a single one in an eight-bit repeating sequence.  This pattern stresses the minimum ones density of 12.5% and should be used when testing facilities set for [[B8ZS]] coding as the 3 in 24 pattern increases to 29.5% when converted to B8ZS.
*'''Min/max''' – Pattern rapid sequence changes from low density to high density.  Most useful when stressing the repeater's [[Automatic Line Build Out|ALBO]] feature.
*'''All ones (or mark)''' – A pattern composed of ones only.  This pattern causes the repeater to consume the maximum amount of power. If DC to the repeater is regulated properly, the repeater will have no trouble transmitting the long ones sequence. This pattern should be used when measuring span power regulation.  An unframed all ones pattern is used to indicate an [[Alarm indication signal|AIS]] (also known as a ''blue alarm'').
*'''All zeros''' – A pattern composed of zeros only.  It is effective in finding equipment misoptioned for [[Alternate Mark Inversion|AMI]], such as fiber/radio multiplex low-speed inputs.
*'''Alternating 0s and 1s''' - A pattern composed of alternating ones and zeroes.
*'''2 in 8''' – Pattern contains a maximum of four consecutive zeros. It will not invoke a B8ZS sequence because eight consecutive zeros are required to cause a B8ZS substitution. The pattern is effective in finding equipment misoptioned for B8ZS.
*'''Bridgetap''' - [[Bridge tap]]s within a span can be detected by employing a number of test patterns with a variety of ones and zeros densities. This test generates 21 test patterns and runs for 15 minutes. If a signal error occurs, the span may have one or more bridge taps. This pattern is only effective for T1 spans that transmit the signal raw. Modulation used in [[HDSL]] spans negates the bridgetap patterns' ability to uncover bridge taps.
*'''Multipat''' - This test generates five commonly used test patterns to allow [[Digital Signal 1|DS1]] span testing without having to select each test pattern individually.  Patterns are: all ones, 1:7, 2 in 8, 3 in 24, and QRSS.
*'''T1-DALY''' and '''55 OCTET''' - Each of these patterns contain fifty-five (55), eight bit octets of data in a sequence that changes rapidly between low and high density. These patterns are used primarily to stress the ALBO and equalizer circuitry but they will also stress timing recovery. 55 OCTET has fifteen (15) consecutive zeroes and can only be used unframed without violating one's density requirements. For framed signals, the T1-DALY pattern should be used. Both patterns will force a B8ZS code in circuits optioned for B8ZS.