Editing ISDN (section)

=== Configurations ===

In ISDN, there are two types of channels, ''B'' (for "bearer") and ''D'' (for "data"). ''B channels'' are used for data (which may include voice), and ''D channels'' are intended for signaling and control (but can also be used for data).

There are two ISDN implementations. Basic Rate Interface (BRI), also called basic rate access (BRA)&nbsp;— consists of two B channels, each with bandwidth of 64 [[kbit/s]], and one D channel with a bandwidth of {{nowrap|16 kbit/s}}. Together these three channels can be designated as 2B+D. Primary Rate Interface (PRI), also called primary rate access (PRA) in Europe&nbsp;— contains a greater number of B channels and a D channel with a bandwidth of {{nowrap|64 kbit/s}}. The number of B channels for PRI varies according to the nation: in North America and Japan it is 23B+1D, with an aggregate bit rate of 1.544 [[Mbit/s]] ([[Digital Signal 1|T1]]); in Europe, India and Australia it is 30B+2D, with an aggregate bit rate of {{nowrap|2.048 Mbit/s}} ([[E-carrier|E1]]). [[Broadband Integrated Services Digital Network]] (BISDN) is another ISDN implementation and it is able to manage different types of services at the same time. It is primarily used within [[network backbone]]s and employs [[Asynchronous Transfer Mode|ATM]].

Another alternative ISDN configuration can be used in which the B channels of an ISDN BRI line are [[Channel bonding|bonded]] to provide a total duplex bandwidth of {{nowrap|128 kbit/s}}. This precludes use of the line for voice calls while the internet connection is in use. The B channels of several BRIs can be bonded, a typical use is a 384K videoconferencing channel.

Using [[B8ZS|bipolar with eight-zero substitution]] encoding technique, call data is transmitted over the data (B) channels, with the signaling (D) channels used for call setup and management. Once a call is set up, there is a simple {{nowrap|64 kbit/s}} synchronous bidirectional data channel (actually implemented as two simplex channels, one in each direction) between the end parties, lasting until the call is terminated. There can be as many calls as there are bearer channels, to the same or different end-points. Bearer channels may also be [[multiplexing|multiplexed]] into what may be considered single, higher-bandwidth channels via a process called B channel BONDING, or via use of Multi-Link PPP "bundling" or by using an H0, H11, or H12 channel on a PRI.

The D channel can also be used for sending and receiving [[X.25]] data packets, and connection to X.25 packet network, this is specified in [[X.31]]. In practice, X.31 was only commercially implemented in the UK, France, Japan and Germany.