ADI Bumble Bee
Template:Infobox aircraft The ADI Bumble Bee (sometimes Hollmann Bumble Bee) is an ultralight gyrocopter marketed by Aircraft Designs Inc (ADI). It was the first of its kind when it flew in 1983 and is still available in plans form for homebuilding.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref><ref name="Cliche">Cliche, Andre: Ultralight Aircraft Shopper's Guide 8th Edition, page F-1. Cybair Limited Publishing, 2001. Template:ISBN</ref><ref name="KitplanesFeb2005">Downey, Julia: 2005 Trikes 'Chutes and Rotorcraft Directory, Kitplanes, Volume 22, Number 2, February 2005, page 54. Belvoir Publications. ISSN 0891-1851</ref><ref name="WDLA04">Bertrand, Noel; Rene Coulon; et al: World Directory of Leisure Aviation 2003-04, page 203. Pagefast Ltd, Lancaster UK, 2003. ISSN 1368-485X</ref>
It was designed by Martin Hollmann after a back injury (sustained in the crash of the ADI Condor) prevented him from flying his previous design (the ADI Sportster) on account of not being able to lift the rotor assembly.Template:Citation needed
Design and developmentEdit
The Bumble Bee is a simple and lightweight design that can be built to comply with the US FAR 103 Ultralight Vehicles rules, including the category's maximum empty weight of Template:Convert. The aircraft has a standard empty weight of Template:Convert.<ref name="Cliche" />
The aircraft consists of an open frame based on a keel tube, which supports the nose wheel at the front and the tail at the back. The pilot's seat, the engine and rotor assembly are bolted to the same keel tube. A control stick cyclically controls rotor pitch angle. The powerplant specified is a Template:Convert, twin-cylinder, two-stroke, air-cooled, single ignition Rotax 447 mounted in pusher configuration. The Template:Convert Kawasaki 440 engine has also been used. The landing gear is of tricycle configuration, uses plastic-spoked wheels to reduce weight and does not include suspension. A horizontal tailplane maintains the aircraft pitch angle in flight and a large fin and rudder is provided. The main rotor system is of low-inertia and requires pilot skill to manage energy on landing.<ref name="Cliche" /><ref name="WDLA04" />
The aircraft plans cost US$160 in 2001. Construction time is estimated as 400 hours, much of which is consumed fabricating the composite rotor blades.<ref name="Cliche" />