Template:Short description {{#invoke:other uses|otheruses}}

File:Nowitna river.jpg
This picture of the Nowitna River in Alaska shows two oxbow lakes – a short one at the bottom of the picture and a longer, more curved one at the middle-right. The picture also shows that a third oxbow lake is probably in the making: the isthmus or bank in the centre of the most prominent meander is very narrow – much narrower than the width of the river; eventually, the two sections of river on either side of an isthmus like that tend to break through and create a new, straighter course; a new river bank then starts to accumulate, sealing off the meander and leaving another oxbow lake.

An oxbow lake is a U-shaped lake or pool that forms when a wide meander of a river is cut off, creating a free-standing body of water. The word "oxbow" can also refer to a U-shaped bend in a river or stream, whether or not it is cut off from the main stream.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref><ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> It takes its name from an oxbow which is part of a harness for oxen to pull a plough or cart.

In South Texas, oxbows left by the Rio Grande are called resacas. In Australia, oxbow lakes are called billabongs.

GeologyEdit

File:Meander Oxbow development.svg
A meander develops into an oxbow lake

An oxbow lake forms when a meandering river erodes through the neck of one of its meanders. This takes place because meanders tend to grow and become more curved over time. The river then follows a shorter course that bypasses the meander.<ref name=NatGeo>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> The entrances to the abandoned meander eventually silt up, forming an oxbow lake.<ref name=ConstantineEtal2010>Template:Cite journal</ref> Oxbow lakes are stillwater lakes, with no current flowing through them, which causes the lake bed to gradually accumulate silt, becoming a bog or swamp and then evaporating completely.<ref name=NatGeo/><ref>Template:Cite journal</ref>

When a river reaches a low-lying plain, often in its final course to the sea or a lake, it meanders widely. In the vicinity of a river bend, deposition occurs on the convex bank (the bank with the smaller radius). In contrast, both lateral erosion and undercutting occur on the cut bank or concave bank (the bank with the greater radius). Continuous deposition on the convex bank and erosion of the concave bank of a meandering river cause the formation of a very pronounced meander with two concave banks getting closer. The narrow neck of land between the two neighboring concave banks is finally cut through, either by lateral erosion of the two concave banks or by the strong currents of a flood. When this happens a new, straighter river channel develops—and an abandoned meander loop, called a cutoff, forms. When deposition finally seals off the cutoff from the river channel, an oxbow lake forms. This process can occur over a time from a few years to several decades, and may sometimes become essentially static.<ref name=ConstantineEtal2010/>

The gathering of erosion products near the concave bank and the transporting of them to the convex bank is the work of the secondary flow across the floor of the river in the vicinity of a river bend. The process of silt deposition, sand and gravel on the convex bank is clearly illustrated in point bars.<ref name="hickin">Template:Cite book</ref>

The effect of the secondary flow can be demonstrated using a circular bowl. Partly fill the bowl with water and sprinkle dense particles such as sand or rice into the bowl. Set the water into circular motion with one hand or a spoon. The dense particles quickly sweep into a neat pile in the center of the bowl. This is the mechanism that leads to the formation of point bars and contributes to the formation of oxbow lakes. The primary flow of water in the bowl is circular and the streamlines are concentric with the side of the bowl. However, the secondary flow of the boundary layer across the floor of the bowl is inward toward the center. The primary flow might be expected to fling the dense particles to the perimeter of the bowl, but instead the secondary flow sweeps the particles toward the center.<ref>Template:Cite journal </ref>

The curved path of a river around a bend makes the water's surface slightly higher on the outside of the bend than on the inside. As a result, at any elevation within the river, water pressure is slightly greater near the outside of the bend than on the inside. A pressure gradient toward the convex bank provides the centripetal force necessary for each parcel of water to follow its curved path.

The boundary layer that flows along the river floor does not move fast enough to balance the pressure gradient laterally across the river. It responds to this pressure gradient, and its velocity is partly downstream and partly across the river toward the convex bank.<ref name="hickin" /><ref>Template:Cite journal</ref> As it flows along the floor of the river, it sweeps loose material toward the convex bank. This flow of the boundary layer is significantly different from the speed and direction of the primary flow of the river, and is part of the river's secondary flow.

File:Oxbow lake.jpg
A Horseshoe or oxbow lake near Hughes, Arkansas, on the border between Arkansas and Mississippi. The bulges in the border reflect changes in the course of the river; when the river shifted its course and cut off the former channel, the border remained unchanged.

River flood plains that contain rivers with a highly sinuous platform are populated by longer oxbow lakes than those with low sinuosity. This is because rivers with high sinuosity have larger meanders, and greater opportunity for longer lakes to form. Rivers with lower sinuosity are characterized by fewer cutoffs and shorter oxbow lakes due to the shorter distance of their meanders.<ref>Template:Cite journal</ref>

Oxbow lake ecologyEdit

Oxbow lakes serve as important wetland ecosystems. In the United States, oxbow lakes serve as the primary habitat for water tupelo and the iconic bald cypress.<ref name="Shankman1994">Template:Cite journal</ref> The numerous oxbow lakes of the Amazon River are a favorable habitat for the giant river otter.<ref name=NatGeo/> Oxbow lakes may also be suitable locations for aquaculture.<ref>Template:Cite journal</ref>

Oxbow lakes contribute to the health of a river ecosystem by trapping sediments and agricultural runoff, thereby removing them from the main river flow. However, this is destructive of the oxbow lake ecosystem itself.<ref>Template:Cite journal</ref> Oxbow lakes are also vulnerable to heavy metal contamination from industrial sources.<ref>Template:Cite journal</ref>

Artificial oxbow lakesEdit

Oxbow lakes may be formed when a river channel is straightened artificially to improve navigation or for flood alleviation. This occurred notably on the upper Rhine in Germany in the nineteenth century.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref>

An example of an entirely artificial waterway with oxbows is the Oxford Canal in England. When originally constructed, it had a very meandering course, following the contours of the land, but the northern part of the canal was straightened out between 1829 and 1834, reducing its length from approximately Template:Convert and creating a number of oxbow-shaped sections isolated from the new course.<ref>Template:Cite book</ref>

Notable examplesEdit

There has also been a possible oxbow lake postulated in Saraswati Flumen near Ontario Lacus on Saturn's moon Titan.<ref>Template:Cite journal</ref>

See alsoEdit

Template:Portal Template:Div col

Template:Div col end

ReferencesEdit

Template:Reflist

External linksEdit

Template:Sister project

Template:River morphology Template:Authority control