Trieste (bathyscaphe)

Template:Short description Template:Use dmy dates

Template:Infobox ship image Template:Infobox ship career Template:Infobox ship career Template:Infobox ship characteristics

Trieste is a Swiss-designed, Italian-built deep-diving research bathyscaphe. In 1960, it became the first crewed vessel to reach the bottom of Challenger Deep in the Mariana Trench, the deepest point in Earth's seabed.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> The mission was the final goal for Project Nekton, a series of dives conducted by the United States Navy in the Pacific Ocean near Guam. The vessel was piloted by Swiss oceanographer Jacques Piccard and US Navy lieutenant Don Walsh. They reached a depth of about Template:Convert.

The bathyscaphe was designed by Swiss scientist Auguste Piccard, the father of pilot Jacques Piccard. It was built in Italy and first launched in 1953. The vessel was first owned and operated by the French Navy until it was purchased by the US Navy in 1958. It was taken out of service in 1966. Since the 1980s, it has been on exhibit in the National Museum of the United States Navy in Washington, D.C.

DesignEdit

Template:More citations needed

File:Trieste nh96807.svg

General arrangement, showing the key features

Trieste was designed by the Swiss scientist Auguste Piccard, based on his previous experience with the bathyscaphe FNRS-2. The term bathyscaphe refers to its capacity to dive and manoeuvre untethered to a ship in contrast to a bathysphere, bathys being ancient Greek meaning "deep" and scaphe being a light, bowl-shaped boat.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> Built in Italy and launched on 26 August 1953 near the Isle of Capri on the Mediterranean Sea<ref name=":0">{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> it was operated in the Mediterranean by the French Navy for several years until it was purchased by the United States Navy in 1958 for US$250,000, equivalent to $Template:Inflation million today.<ref name="9 News">Template:Citation</ref> Trieste consisted of a heavy crew sphere suspended from a hull containing tanks filled with gasoline (petrol) for buoyancy, ballast hoppers filled with iron shot and floodable water tanks to sink.<ref name="MH" /> This general configuration remained the same but after modifications to the hull for Project Nekton, which included the dive to Challenger Deep, Trieste was more than Template:Convert long. The hull was built by Cantieri Riuniti dell'Adriatico, in the Free Territory of Trieste on the border between Italy and Yugoslavia, now in Italy, hence the name. The pressure sphere was built separately and installed on the hull in the Cantiere navale di Castellammare di Stabia, near Naples.

File:Bathyscaphe Trieste sphere.jpg

Pressure sphere, with forward ballast hopper, left

The pressure sphere was attached to the underside of the hull and accommodated two crew who accessed it via a vertical shaft through the hull; this access shaft was not pressurized and flooded with seawater on descent. The sphere was completely self-contained, having a closed-circuit rebreather system with oxygen provided from cylinders while carbon dioxide was scrubbed from the air by being passed through canisters of soda-lime. Batteries provided electrical power. Piccard's original pressure sphere was built by Acciaierie Terni of steel forged in two hemispheres and welded to form a sphere Template:Convert in diameter and Template:Convert thick,<ref>Template:Citation</ref> This pressure sphere was replaced in December 1958 with another cast by the Krupp Steel Works<ref>Template:Citation</ref> of Essen, Germany in three sections; an equatorial ring and two caps, which were finely machined and joined by the Ateliers de Constructions Mécaniques de Vevey. The new sphere was also steel, but smaller at Template:Convert diameter and with thicker walls, at Template:Convert,<ref name="9 News" /> calculated to withstand the Template:Convert pressure at the bottom of Challenger Deep plus a substantial factor of safety. The new sphere weighed Template:Convert in air and Template:Convert in water giving it an average specific gravity 2.6 times (or 1.6 times greater than) that of seawater (13÷(13−8)).<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref><ref name=":1">{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> Outside observations by the crew were made through a porthole made from a single, tapered block of acrylic glass; the only transparent material available that could withstand the pressure. Outside illumination was by quartz arc-light bulbs, which could withstand the pressure without modification.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref>

File:Bathyscaphe Trieste Piccard-Walsh.jpg

Don Walsh and Jacques Piccard aboard Trieste

The buoyancy tanks were filled with gasoline, which floats in water and is similarly incompressible. Changes in the volume of the gasoline caused by any slight compression or temperature changes were accommodated by the free flow of seawater into and out of the bottom of the tanks during a dive via valves, equalising the pressure and allowing them to be lightly built.
Ballast was held in two conical hoppers fore and aft of the crew sphere each containing Template:Convert of iron shot. This shot ballast allowed the craft to sink, and its release caused it to ascend. The iron shot was locked in place at the throats of the hoppers by electromagnets thus was released either by switching the electromagnets off or automatically in the event of an electrical failure. Progressive release allowed buoyancy trim. Compressed-air–driven variable-buoyancy pressure vessels typically used in submarines are not feasible at extreme pressure.
Water tanks at each end of the hull were pumped out for flotation, lifting, and towing on the surface and fully flooded to allow sinking.<ref>Template:Citation</ref>
Following its acquisition by the United States Navy, Trieste was modified extensively by the Naval Electronics Laboratory, San Diego, California, tested in the Pacific Ocean over the next few years, and culminated in a dive to the bottom of Challenger Deep 23 January 1960.<ref name="MH">{{#invoke:citation/CS1|citation |CitationClass=web }}</ref>

The Mariana Trench divesEdit

File:Bathyscaphe Trieste with USS Lewis (DE-535) over the Marianas Trench, 23 January 1960 (NH 96797).jpg

Trieste just before the Mariana dive 23 January 1960, seen escorted by USS Lewis

Trieste departed San Diego on 5 October 1959 for Guam aboard the freighter Santa Maria to participate in Project Nekton, a series of very deep dives in the Mariana Trench.

On 23 January 1960, it reached the ocean floor in the Challenger Deep (the deepest southern part of the Mariana Trench), carrying Jacques Piccard and Don Walsh.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> This was the first time a vessel, crewed or uncrewed, had reached the deepest known point of the Earth's oceans. The onboard systems indicated a depth of Template:Convert, although this was revised later to Template:Convert; fairly recently, more accurate measurements have found Challenger Deep to be between Template:Convert and Template:Convert deep.<ref>Template:Cite news</ref>

The descent to the ocean floor took 4 hours 47 minutes at a descent rate of Template:Convert.<ref>NGC: On the sea floor</ref><ref>To the Depths in Trieste Template:Webarchive, University of Delaware College of Marine Studies</ref> After passing Template:Convert, one of the outer Plexiglas window panes cracked, shaking the entire vessel.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}, Rolex Deep Sea Special, Written January 2006.</ref> The two men spent twenty minutes on the ocean floor. The temperature in the cabin was 7 °C (45 °F) at the time. While at maximum depth, Piccard and Walsh unexpectedly regained the ability to communicate with the support ship, USS Wandank (ATA-204), using a sonar/hydrophone voice communications system.<ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> At a speed of almost Template:Convert – about five times the speed of sound in air – it took about seven seconds for a voice message to travel from the craft to the support ship and another seven seconds for answers to return.

While at the bottom, Piccard and Walsh reported observing a number of sole and flounder (both flatfish).<ref>Template:Cite video</ref><ref>Template:Cite news</ref> The accuracy of this observation has later been questioned and recent authorities do not recognize it as valid.<ref>Template:Cite journal</ref> The theoretical maximum depth for fish is at about Template:Convert, beyond which they would become hyperosmotic.<ref name=Wolff1961>Template:Cite journal</ref><ref name=Jamieson2012>Template:Cite journal</ref><ref>Template:Cite journal</ref> Invertebrates such as sea cucumbers, some of which potentially could be mistaken for flatfish, have been confirmed at depths of Template:Convert and more.<ref name=Wolff1961/><ref>Template:Cite book</ref> Walsh later said that their original observation could be mistaken as their knowledge of biology was limited.<ref name=Jamieson2012/> Piccard and Walsh noted that the floor of the Challenger Deep consisted of "diatomaceous ooze". The ascent took 3 hours and 15 minutes. The National Museum of the Navy commemorated the 60th anniversary of the dive in January 2020.<ref name=":2">{{#invoke:citation/CS1|citation |CitationClass=web }}</ref>

Other deep dives and retirementEdit

File:Trieste Museum1.JPG

The Trieste at the National Museum of the United States Navy

The Trieste performed a number of deep dives in the Mediterranean prior to being purchased by the U.S. Navy in 1958.<ref name=":0"/> It conducted 48 dives exceeding Template:Convert between 1953 and 1957 as the Batiscafo Trieste.

Beginning in April 1963, Trieste was modified and used in the Atlantic Ocean to search for the missing nuclear submarine Template:USS.<ref name=":1" /> Trieste was delivered to Boston Harbor by USS Point Defiance (LSD-31) under the command of Captain H. H. Haisten. In August 1963, Trieste found debris of the wreck off the coast of New England, Template:Convert below the surface after several dives.<ref name=":1" /><ref name="brand">Template:Cite journal</ref> Trieste's participation in the search earned it the Navy Unit Commendation.

Following the mission, Trieste was returned to San Diego and taken out of service in 1966.<ref name=":1" /><ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> Between 1964 and 1966, Trieste was used to develop its replacement, the Trieste II, with the original Terni pressure sphere reincorporated in its successor.<ref name=":0" /><ref>{{#invoke:citation/CS1|citation |CitationClass=web }}</ref> In early 1980, it was transported to the Washington Navy Yard where it remains on exhibit today in the National Museum of the U.S. Navy, along with the Krupp pressure sphere.<ref name=":2" />